Loading ...
Loading ...
Loading ...
Steps
Note
The funcon is supported by parts of the device models.
1.
Move the cursor and select Comm. → Wi-Fi .
2.
Press * to enter the Wi-Fi page.
Figure 6-3 Wi-Fi Page
3.
Enable the WLAN funcon.
4.
Select a Wi-Fi from the list and set the Wi-Fi parameters, including the Wi-Fi password and
DHCP.
-
Enable DHCP, and the system will automacally assign IP address for the Wi-Fi.
-
Disable DHCP, and you should set the IP address, subnet mask, and gateway.
5.
Press * to save the sengs and exit the page.
6.3.3 Set EHome Parameters
Set EHome parameters and the device can upload data via EHome protocol.
Before You Start
Make sure your device has connect to a network.
Steps
1.
Move the cursor and select Comm. → EHome .
Access Control Terminal User Manual
29
Loading ...
Loading ...
Loading ...