Loading ...
Loading ...
Loading ...
Figure 4-4 Wiring of Wiegand Card Reader
Note
●
Set the dial-up of the external card reader as 2 when connected to the access control terminal.
●
The external power supply and the access control terminal should use the same GND cable.
4.5 Device Wiring as RS-485 Card Reader
The access control terminal can be switched into the card reader mode. It can access to the access
control as a RS-485 card reader.
Note
When the access control terminal works as a card reader, it only supports being connected to the
controller, but does not support alarm input or output, or the connecon of external devices.
The wiring diagram is as follows:
Access Control Terminal User Manual
20
Loading ...
Loading ...
Loading ...