Loading ...
Loading ...
Loading ...
Chapter 2 To Set the Vertical System RIGOL
DS8000-R User Guide 2-11
Channel Label
The instrument uses the channel number to mark the corresponding channel by
default. For ease of use, you can also set a label for each channel. For example,
"
".
Click the CH1 channel status label to enter the CH1 setting menu. Click More →
Label to enter the label setting menu. You can use the built-in label or manually
input a label. Three input methods are available for you to input a label name,
including Chinese, English, and Traditional Chinese.
The label setting menu includes the following menu items.
âš« Click Display to turn on or off the display of the channel label. If it is enabled,
the label will be displayed at the left side of the waveform. When on, CH1 is, by
default, displayed to be the channel label.
âš« Click Library to select the preset labels such as CH1, ACK, ADDR, BIT, CLK, CS,
DATA, IN, MISO, MOSI, OUT, RX and TX.
âš« Click Label and the label editing interface is automatically displayed, as shown in
Figure 2-3. You can input the label manually. For the label input method, refer to
"To Create a Folder".
Figure 2-3 Label Editing Interface
For example, set the label to "
". In the virtual keypad, click "Caps" (only available
to be selected for English input method) to switch the uppercase or lowercase mode.
Select "C" and click it to complete inputting C. Use the same method to input "hn1".
After finishing the input, click OK to finish the editing. If Display is enabled, the
label
will be displayed at the left of CH1 waveform.
To delete or modify the input characters, move the cursor to the right side of the
character required to be deleted or modified, and then click the delete key to delete
the character. To modify the characters, input the desired character again.
Label Input Area Input Selection Area Virtual Keypad Delete Key
Upper/Lower
Case Switch
Loading ...
Loading ...
Loading ...