Loading ...
Loading ...
Loading ...
RIGOL Chapter 5 To Trigger the Oscilloscope
5-52 DS8000-R User Guide
Zone Trigger
DS8000-R series oscilloscope supports the zone trigger and provides two rectangle
areas: Trigger zone A and Trigger zone B. You can set the trigger conditions to
"Intersect" or "Not intersect". Refer to "Rectangle Drawing" to select "Trigger
zone A" or "Trigger zone B" to open the zone trigger setting menu. You can also click
on the function navigation icon to open the navigation menu. Then click Measure →
Analyze → Zone trigger to enter the zone trigger setting menu.
Enable or disable Trigger zone A or Trigger zone B:
Click Zone A enable or Zone B enable continuously to enable or disable Trigger
zone A or Trigger zone B. You can also refer to "Rectangle Drawing" to select
"Trigger zone A" or "Trigger zone B" to enable Trigger zone A or Trigger zone B. If
both Trigger zone A and Trigger zone B are disabled, then the zone trigger function is
disabled. At this time, you must enable either of them to re-enable the zone trigger.
Note: The zone trigger function is disabled when you enable "XY Mode" or "ROLL
Mode".
Select Source A or Source B:
Click Source A or Source B to select the desired source. The available sources
include CH1-CH4. The zone name color and the zone color are the same as the color
of the selected source channel.
Set the conditions for Trigger zone A and Trigger zone B:
Click Zone A or Zone B to select "Intersect" or "Not intersect".
If you enable Zone A, select CH1 as Source A, and select "Intersect" as the condition,
as shown in the figure below.
If you enable Zone A, select CH1 as Source A, and select "Not intersect" as the
condition, the following figure is displayed.
Loading ...
Loading ...
Loading ...