Loading ...
Loading ...
Loading ...
Chapter 6 Operations and Measurements RIGOL
DS8000-R User Guide 6-37
ratio (%).
➢ Cursor A is a vertical solid line (
is displayed at the bottom of the screen),
and Cursor B is a vertical dotted line (
is displayed at the bottom of the
screen).
➢ In the X-Y cursor mode, X cursor is used to measure the waveform
amplitude of CH1.
âš« Y Cursor
Y cursor is a horizontal solid/dotted line that is used to make vertical adjustment.
It can be used to measure amplitude (the unit is the same as that of the source
channel amplitude) and ratio (%).
➢ Cursor A is a horizontal solid line (
is displayed at the right section of the
screen), and Cursor B is a horizontal dotted line (
is displayed at the
right section of the screen).
➢ In the X-Y cursor mode, Y cursor is used to measure the waveform
amplitude of CH2.
Click on the function navigation icon at the lower-left corner of the screen to
open the function navigation. Then click on the cursor icon
to open the cursor
measurement menu.
In the cursor measurement menu, click Mode to select the desired cursor mode. The
available modes are "Manual", "Track", "XY", and "Measure". When you select "OFF",
the cursor measurement function is disabled.
Note: When the Time Base Mode is set to "XY", the XY cursor measurement mode is
valid.
Manual Mode
In this mode, you can adjust the cursor manually to measure the value of the
waveforms of the specified source at the current cursor. The measurement results
are displayed at the upper-left corner of the screen. When you change the cursor
position, the measurement results will be changed accordingly.
Click Mode to select "Manual" to enable the manual cursor measurement function. If
the settings for the parameter such as "Select", "Source", "Hori. Unit", and "Vert.
Unit" are different, the measurement results will be different for cursor measurement.
The measurement results are displayed at the upper-left corner of the screen, as
shown in the figure below.
Loading ...
Loading ...
Loading ...