Loading ...
Loading ...
Loading ...
Chapter 6 Operations and Measurements RIGOL
DS8000-R User Guide 6-33
2
． Source Selection
For different measurement categories, the selection methods for measurement
sources are different.
âš« Horizontal and vertical parameter measurement
Click Measure → Add → Source A to select the desired channel for
measurement. The available channels include CH1-CH4 and Math1-Math4.
âš« Other (Delay and Phase) parameter measurement
Click Measure → Add → Source A (Source B) to set the two source
channels for the current measurement category. The available channels
include CH1-CH4 and Math1-Math4.
3． Indicator
Click Indicator continuously to enable or disable the indicator. You can also
Click Measure → Add → Indicator to enable or disable the indicator. For
details, refer to descriptions in "Measure Mode".
4
． Measurement Settings
Click Measure → Setting to enter the sub-menu of measurement.
âš« Click Mode to select the measurement mode to "Normal" or
"Precision".
➢ Normal: executes measurement of up to 1 Mpts.
➢ Precision: executes measurement of up to 200 Mpts, improving the
resolution of measurement results. Note, in this mode, the refresh rate
of the waveforms may be reduced.
Note: When the memory depth is less than or equal to 1K points or the
"High Res" mode is opened, the "Precision" measurement mode will
automatically switch to the "Normal" measurement mode.
âš« Click Type to select "Threshold", "Range", or "Amp Method".
➢ Select "Threshold", and then make the following settings:
--Click Source to select the desired channel for measurement
(CH1-CH4 or Math1-Math4).
Tip
In the measurement category area, click to select "Analyze". The following
figure is displayed. Select "Counter", "DVM", "Histogram", "Power" (required
to install the option DS8000-R-PWR), "Eye", or "Jitter" (required to install the
option DS8000-R-JITTER) to enter the corresponding function setting menu.
For descriptionsn about these functions, refer to relevant chapters.
Loading ...
Loading ...
Loading ...