Loading ...
Loading ...
Loading ...
RIGOL Chapter 5 To Trigger the Oscilloscope
5-54 DS8000-R User Guide
Trigger Output Connector
The trigger output connector ([TRIG OUT]) on the rear panel of DS8000-R series
can output trigger signals (hardware trigger) determined by the current setting.
Figure 5-24 Trigger Output Connector
Click on the function navigation icon to open the navigation menu. Then click Utility
→ System → AUX Out to select "TrigOut". A signal which reflects the current
capture rate of the oscilloscope can be output from the [TRIG OUT] connector each
time a trigger is generated by the oscilloscope. If this signal is connected to a
waveform display device to measure the frequency, the measurement result is the
same as the current capture rate.
Note: If you click Utility → System → AUX Out to select "PassFail", then in the
pass/fail test, when a pass/fail event is detected, the oscilloscope outputs a pulse
from the rear-panel [TRIG OUT] connector.
Trigger Output Connector
Loading ...
Loading ...
Loading ...