Axis 02811-001 Axis P1465-LE-3 User Manual

Loading ...

AXIS P1465-LE-3 License Plate Veriﬁer Kit

The device interface

The Simple Network Management Protocol (SNMP) allows remote management of network devices.

SNMP: Select the version of SNMP to use.

• v1 and v2c:

- Read community: Enter the community name that has read-only access to all supported SNMP objects. The

default value is public.

- Write community: Enter the community name that has read/write access to all supported SNMP objects

(except read-only objects). The default value is write.

- Activate traps: Turn on to activate trap reporting. The device uses traps to send messages for important

events or status changes to a management system. In the device interface, you can set up traps for SNMP v1

and v2c. Traps are automatically turned off if you change to SNMP v3 or turn off SNMP. If you use SNMP v3,

you can set up traps through the SNMP v3 management application.

- Trap address: Enter the IP address or host name of the management server.

- Trap community: Enter the community to use when the device sends a trap message to the management

system.

- Traps:

- Cold start: Sends a trap message when the device starts.

- Warm start: Sends a trap message when you change an SNMP setting.

- Link up: Sends a trap message when a link changes from down to up.

- Authentication failed: Sends a trap message when an authentication attempt fails.

Note

All Axis Video MIB traps are enabled when you turn on SNMP v1 and v2c traps. For more information, see

AXIS OS Portal > SNMP.

• v3: SNMP v3 is a more secure version, which provides encryption and secure passwords. To use SNMP v3, we

recommend you to activate HTTPS, as the password is then sent through HTTPS. This also prevents unauthorized

parties to access unencrypted SNMP v1 and v2c traps. If you use SNMP v3, you can set up traps through the SNMP v3

management application.

- Password for the account “initial”: Enter the SNMP password for the account named “initial”. Although the

password can be sent without activating HTTPS, we don’t recommend it. The SNMP v3 password can only

be set once, and preferably only when HTTPS is enabled. Once the password is set, the password eld is no

longer displayed. To set the password again, you must reset the device to factory default settings.

Security

Certicates

Certicates are used to authenticate devices on a network. The device supports two types of certicates:

• Client/server certicates

A client/server certicate validates the device’s identity, and can be self-signed or issued by a Certicate Authority (CA).

A self-signed certicate offers limited protection and can be used before a CA-issued certicate has been obtained.

• CA certicates

You can use a CA certicate to authenticate a peer certicate, for example to validate the identity of an authentication

server when the device connects to a network protected by IEEE 802.1X. The device has several pre-installed CA

certicates.

These formats are supported:

• Certicate formats: .PEM, .CER, and .PFX

• Private key formats: PKCS#1 and PKCS#12

Important

If you reset the device to factory default, all certicates are deleted. Any pre-installed CA certicates are reinstalled.

Filter the certicates in the list.

Add certicate : Click to add a certicate.

Loading ...

Axis 02811-001 P1465-LE-3 License Plate Verifier Kit

Axis P1465-LE-3 User Manual - Page 52