Loading ...
Loading ...
Loading ...
S006
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
About this task
Attention:
• Read
“Safety inspection checklist” on page iv and “Installation guidelines” on page 41 to ensure that you
work safely.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Step 1. Make sure the cage bar is installed in the chassis. To install the cage bar, see
“Install the server
cover” on page 147
.
Step 2. If necessary, install the 3.5-inch drive assembly to the optical drive cage. See
“Simple-swap drive
and drive cage replacement (bay 3)” on page 62
.
Step 3. Install the optical drive cage.
a.
Align the four pins on the sides of the optical drive cage with the four slots on the chassis
and cage bar; then, lower the optical drive cage into the chassis.
b.
Ensure the optical drive cage is seated correctly; then, rotate the optical drive cage handle
toward the front of the chassis to secure the optical drive cage into place.
Chapter 3. Hardware replacement procedures 79
Loading ...
Loading ...
Loading ...