Loading ...
Loading ...
Loading ...
After you finish
1. Install a 3.5-inch drive to drive bay 1 or a 2.5-inch drive to drive bay 2, see
“Install a simple-swap drive
(bay 1-2)” on page 53
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a simple-swap drive (bay 1-2)
Follow this procedure to install a simple-swap drive to bay 1 or bay 2.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
“Safety inspection checklist” on page iv and “Installation guidelines” on page 41 to ensure that you
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Make sure the type of drives to be installed is supported. Following are the types supported:
– 3.5-inch simple-swap hard-disk drive or solid-state drive in drive bay 1 and drive bay 3
– 2.5-inch simple-swap solid-state drive in drive bay 2
For a complete list of supported optional devices for the server, see
https://static.lenovo.com/us/en/
serverproven/index.shtml
.
• If there are more than one drives to be installed, determine installation order based on the following rules:
– Start with solid-state drives, and proceed with hard-disk drives.
– When installing one 3.5-inch solid-state drive and one 3.5-inch hard-disk drive, install the solid-state
drive in bay 1 and the hard-disk drive in bay 3.
– Start with the drive with the lowest capacity.
– Start with bay 1, proceed to bay 2, and bay 3.
Note: Drives of different types and different capacities are allowed to be installed in one server, but not in
the same RAID array. The drives in a single RAID array must be the same type and the same capacity. See
https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html for more details.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Chapter 3. Hardware replacement procedures 53
Loading ...
Loading ...
Loading ...