Loading ...
Loading ...
Loading ...
Use this menu to set up basic system parameters.
1
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
• Test Tone (Test tone)
Turns the test tone output on or off t_r Speaker Set,
Speaker Distance and Speaker Level settings.
Manual Setup > Basic > Test Tone >
Choices: Off, On
Press A / V on the remote control to select
Manual Setup and then press c>.
Press A / V on the remote control to select
Basic and then press _>.
If you use a handheld SPL meter, hold at arms length and point
upwards so that the meter is in the listening position. With the
meter set to the 70 dB scale and to C SLOW. calibrate each
speaker to 75 dB.
Loud test tones will be output when "On" is selected. In this case.
make sure no children are present in the listening room.
• Speaker Set (Speaker set)
Use to manually adjust any speaker setting.
Manual Setup > Basic > Speaker Set >
Choices: Front, Center, Surround, Surround Back,
Presence, Bass Out, Bass Cross Over, SWFR
Phase
4 Select the desired parameters and then press
E> to access and adjust.
• Most of the parameters described in the basic menu are set
automatically when you run AUTO SETUP. You can use the
basic menu to make further a_ljostments, but we recommend
running AUTO SETUP first.
• You can reset these parameters by performing the AUTO
SETUP procedure (see page 32).
If you are not satisfied with the bass sounds from your speakers.
you can change these settings according to your preference.
Set any THX speakers to Small.
90
Loading ...
Loading ...
Loading ...