Loading ...
Loading ...
Loading ...
IFJ_TFh_io]_IPt#
Use this featnre to reassign digital input/outputs, select the
input signal, rename the inputs, or adjust the level of the
signal input at each jack.
Choices: XM, TUNER, PHONO, CD, CD-R, MD/TAPE,
DVD, DTV, CBL/SAT, VCRI, DVR/VCR2,
V-AUX, MULTI CH
2 Select Input Select and then press C>.
Some paranaeters described below may not be available for all
input sources and some pamnaeters are only available for specific
inpul sources.
Input source Parameter
Antenna Level
XM Volume Trim
Rename
Volume Trim
TUNER
Rename
PHONO
CD
CD-R
MD/TAPE
DVD
DTV
CBL/SAT
VCRI
DVR/VCR2
1/O Assignment
Audio Select
Decoder Mode
Volume Trim
Rename
Audio Select
Decoder Mode
V-AUX
Volume Trim
Rename
Volume Trim
MULTI CH
Multi CH Assign
1
Set AMP/SOURCE/TV to AMP and then press
GUI TOP on the remote control.
The top display appears.
3 Select the desired input source (CD, DVD,
etc.) and then press c> to access and adjust.
• Antenna Level (Antenna level)
Use to display tile XM Satellite Radio reception level.
Input Select > XM > Antenna Level >
Display status: NONE, 0 to 100%
• If the displayed percentage of the reception level is
below the average (approximately 60%), you need to
adjust the orientation of the XM Satellite Radio
antenna for a better percentage of the reception level.
• If NONE is displayed, the XM Satellite Radio antenna
may not be firmly connected to the XM.jack on the rear
panel of this unit. Check the XM Satellite Radio
connection.
The Antenna Level parameter canllOl be ad.justed by using the
remote control. Inslead. you need to adjusl Ihe orientation of Ihe
XM Salellile Radio antenna lk_ra better percentage of the
reception level.
8O
Loading ...
Loading ...
Loading ...