Loading ...
Loading ...
Loading ...
16
repeat the procedure and wipe the area with a
damp sponge and nonabrasive cleaning powder.
To clean the inside of the detachable stem, slide
the stem release button up as far as it will go and
hold as you run water through the stem.
IMPORTANT: Never store the blade or discs on
the motor shaft. The blade or disc should not be
placed on the shaft except when the processor is
about to be used.
FOR YOUR SAFETY
Like all powerful electrical appliances, a food pro-
cessor should be handled with care. Follow these
guidelines to protect you and your family from
misuse that could cause injury.
▶ Handle metal blade and discs carefully. Their
cutting edges are very sharp.
▶ Always place discs on flat, stable surface
before connecting detachable stem.
▶ Never put blade or disc on motor shaft until
work bowl is locked in place.
▶ Always be sure that the blade or disc is down
on motor shaft as far as it will go.
▶ Always insert metal blade in work bowl before
putting ingredients in bowl.
▶ When slicing or shredding food, always use
pusher. Never put your fingers or spatula into
feed tube.
▶ Always wait for blade or disc to stop spinning
before you remove pusher assembly or cover
from work bowl.
▶ Be careful to prevent metal blade from fall-
ing out of work bowl when emptying bowl.
Remove blade before tilting bowl, or hold it in
place with your finger, a spatula or spoon.
▶ Never use pusher assembly if sleeve becomes
detached from pusher. Call Cuisinart
Consumer Service immediately at
1-800-726-0190.
SOME TECHNICAL DATA
The motor in your food processor operates on
standard line operating current. The appropri-
ate voltage and frequency for your machine are
shown on a label under the base.
An automatic, temperature-controlled circuit
breaker in the motor ensures complete protection
against motor burnout. If the processor runs for
an exceptionally long time when chopping, mixing
or kneading a thick or heavy mixture in succes-
sive batches, the motor may overheat. If this
happens, the processor will stop. Turn it off and
wait for the motor to cool off before proceeding.
It will usually cool off within 10 minutes. In extreme
cases, it could take an hour.
Safety switches prevent the machine from operat-
ing when the work bowl or the cover is not locked
into position. The motor stops within seconds
when the motor is turned off, and a fast-stop cir-
cuit stops it instantly when the pusher assembly
is unlocked.
Loading ...
Loading ...
Loading ...