Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 89
NOTE:
If the tonneau cover is installed, make sure
the tonneau cover is fully closed before
closing the tailgate.
Due to the presence of the Center
High-Mounted Stop Light, removal of the
tailgate is not recommended.
GARAGE DOOR OPENER (HOMELINK®) — IF
EQUIPPED
HomeLink® replaces up to three hand-held
transmitters that operate devices such as
garage door openers, motorized gates, lighting
or home security systems. The HomeLink® unit
is powered by your vehicle’s 12V battery.
The HomeLink® buttons, located on the sun
vis
or or the overhead console, designate the
three different HomeLink® channels. The
HomeLink® indicator is located above the
center button.
HomeLink® Buttons
To operate HomeLink®, push and release any
of
the programmed HomeLink® buttons. These
buttons will activate the devices they are
programmed to with each press of the
corresponding HomeLink® button.
NOTE:
HomeLink® is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink®
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accurate
tra
nsmission of the radio-frequency signal it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
Make sure your hand-held transmitter is
programmed to activate the device you are
trying to program your HomeLink® button to.
To erase the channels, place the ignition in the
ON/
RUN position, and push and hold the two
outside HomeLink® buttons (I and III) for up to
20 seconds or until the orange indicator
flashes.
NOTE:
Erasing all channels should only be
performed when programming HomeLink®
for the first time. Do not erase channels when
programming additional buttons.
If you have any problems, or require
assistance, please call toll-free
1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
Programming A Rolling Code
Programming garage door openers that were
manufactured after 1995 can be identified by
the “LEARN” or “TRAIN” button located where
the hanging antenna is attached to the garage
door opener.
2
Loading ...
Loading ...
Loading ...