Loading ...
Loading ...
Loading ...
194 STARTING AND OPERATING
(Continued)
NOTE:
Normal starting of either a cold or a warm
eng
ine is obtained without pumping or pressing
the accelerator pedal.
To Turn Off The Engine Using ENGINE START/
STO
P Button
1. Place the gear selector in PARK, then push
an
d release the ENGINE START/STOP
button.
2. The ignition will return to the OFF mode.
3.
If the gear selector is not in PARK (with
ve
hicle stopped) and the ENGINE START/
STOP button is pushed once, the transmis
-
sion will automatically select PARK and the
eng
ine will turn off, however the ignition will
remain in the ACC mode (NOT the OFF
mode). Never leave a vehicle out of the
PARK position, or it could roll.
4. If the gear selector is in NEUTRAL, and the
ve
hicle speed is below 5 mph (8 km/h),
pus
hing the ENGINE START/STOP button
once will turn the engine off. The ignition will
remain in the ACC mode.
5. If the vehicle speed is above 5 m
ph
(8 km/h), the ENGINE START/STOP button
mus
t be held for two seconds (or three short
pushes in a row) to turn the engine off. The
ignition will remain in the ACC mode (NOT
the OFF mode) if the engine is turned off
when the transmission is not in PARK.
NOTE:
The system will automatically time out and the
i
gn
ition will cycle to the OFF mode after
30
minutes of inactivity if the ignition is left in
the
ACC or RUN (engine not running) mode and
the transmission is in PARK.
ENGINE START/STOP Button Functions — With
Dri
ver’s Foot Off The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates
sim
ilar to an ignition switch. It has three modes:
OFF, ACC, and RUN. To change the ignition
modes without starting the vehicle and use the
accessories, follow these steps:
1. Starting with the ignition in the OFF mode.
2.
Push the ENGINE START/STOP button once
to
place the ignition to the ACC mode
(instrument cluster will display “ACC”).
3. Push the ENGINE START/STOP button a
se
cond time to place the ignition to the RUN
mode (instrument cluster will display
“ON/RUN”).
4. P
ush the ENGINE START/STOP button a third
ti
me to return the ignition to the OFF mode
(instrument cluster will display “OFF”).
AutoPark
AutoPark is a supplemental feature to assist in
placing the vehicle in PARK should the
situations on the following pages occur. It is a
back up system and should not be relied upon
as the primary method by which the driver shifts
the vehicle into PARK.
The conditions under which AutoPark will
eng
age are outlined on the following pages.
WARNING!
Driver inattention could lead to failure to
place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in PARK
by verifying that a solid (not blinking) “P” is
indicated in the instrument cluster display
and on the gear selector. If the "P" indicator
is blinking, your vehicle is not in PARK. As
an added precaution, always apply the
parking brake when exiting the vehicle.
Loading ...
Loading ...
Loading ...