Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 85
4. Move to the inside of the vehicle and lower
both sun visors.
5. Using the provided #T40 T
orx head driver,
rem ove the four Torx head fasteners
located along the interior of the windshield
(two on each side of the header trim).
Interior Torx Head Fastener Locations
(Le
ft Side Shown)
NOTE:
Store all of the mounting bolts in their original
t
hr
eaded holes and tighten for safekeeping, or
in the fastener bin located below the rear seat.
6. Lower the windshield gently until it contacts
th
e footman loop bumpers (if equipped).
Footman Loop Bumpers
7. S
ecure the windshield by passing a cinch
st
rap through the footman loops on either
side of the hood and on the windshield
frame. Tighten the strap to secure the wind
-
shield in place.
Adaptive Cruise Control (ACC)/Forward
Collision Warning (FCW) Sensor Protective
Cover — If Equipped
Your vehicle may be equipped with a protective
cover that is to be used whenever the
windshield is folded down in order to protect the
ACC/FCW sensor. To install the cover, follow the
instructions below:
1. Secure the top part of the cover so that it
hi
nges to the header.
2. Swing the cover down and push on it so that
it
covers the opening.
3. Check to make sure the cover is secured
pr
operly.
NOTE:
Be sure to remove the cover before returning
the
windshield to the normal position. Store the
cover in the cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt
c
an
accumulate in the cover and block the
camera lens. Use a microfiber cloth to clean the
camera lens, module, and inside cover, being
careful not to damage or scratch the module.
1 — Washer Nozzle
2 — Bumper
3 — Footman Loop
CAUTION!
Do Not Overtighten! Damage to the
windshield could result.
2
Loading ...
Loading ...
Loading ...