Loading ...
Loading ...
Loading ...
102 GETTING TO KNOW YOUR VEHICLE
BED RAIL TIE DOWN SYSTEM — IF
EQUIPPED
The Bed Rail Tie Down System allows you to
properly secure cargo in the truck bed.
Bed Rail Tie Down Locations
There are two adjustable utility rail cleats on
eac
h side of the bed that can be used to assist
in securing cargo.
Adjustable Cleat Assembly
Each utility rail cleat must be tightened down in
one
of the detents along either utility rail in
order to keep cargo properly secured.
To move the utility rail cleat to any position on
the
utility rail, turn the cleat retainer nut
counterclockwise several times. Then, pull out
on the utility rail cleat and slide it to the detent
nearest the desired location. Make sure the
utility rail cleat is seated in the detent, and
tighten the nut.
To remove the utility rail cleats from the side
uti
lity rails, slide the cleat to the rectangular
cutout located at the end of the rail toward the
front of the vehicle.
To remove the utility rail cleat from the front
ut
i
lity rail, slide the cleat to the rectangular
cutout located on the left side of the rail.
TONNEAU COVER — IF EQUIPPED
The Tonneau Cover can be installed on the
truck bed to keep cargo out of view, and protect
from inclement weather.
The Tonneau Cover consists of the following
fea
tures:
Easy roll up cover
Tonneau fore/aft locator
Crossbar inside bed locator
Rear latches
Stowage straps
NOTE:
The Tonneau Cover can be rolled up and
sec
ured at the front of the truck bed without
removing it completely.
CAUTION!
The maximum load per cleat should not
exceed 250 lbs (113 kg) and the angle of the
load on each cleat should not exceed 45
degrees above horizontal, or damage to the
cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
Loading ...
Loading ...
Loading ...