User Manual - Page 321

For 2020 Gladiator.

Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 319
NOTE:
Use only manufacturer approved A/C system
PAG
compressor oil, and refrigerants.
Air Conditioning (A/C) Filter Replacement
The A/C air filter is located in the fresh air inlet
behind the glove compartment. Perform the
following procedure to replace the filter:
1. Open the glove compartment and remove
al
l contents.
2. Push up on the glove compartment travel
st
op and lower the door.
Glove Compartment Travel Stop
3. Pivot the glove compartment downward.
4.
Disengage the two retaining tabs that
se
cure the air filter access door to the HVAC
housing.
Air Filter Retaining Tabs
5. Remove the air filter from the HVAC air inlet
ho
using. Pull the filter elements out
pinching them to the right for clearance.
Air Filter
6. I
nstall the A/C air filter with the air filter
po
sition indicators pointing in the same
direction as removal.
7. Close A/C air filter access door and secure
re
taining tabs.
WARNING!
Do not remove the cabin air filter while the
vehicle is running, or while the ignition is in
the ACC or ON/RUN mode. With the cabin air
filter removed and the blower operating, the
blower can contact hands and may propel dirt
and debris into your eyes, resulting in
personal injury.
CAUTION!
The cabin air filter is identified with an arrow
to indicate airflow direction through the filter.
Failure to properly install the filter will result
in the need to replace it more often.
7
Loading ...
Loading ...
Loading ...