Loading ...
Loading ...
Loading ...
If you live in Canada
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals after broadcasting for a few seconds.
Therefore, these signals may not last long
enough for the integrated garage door
opener. The signal is not recognized during
programing. Comparable with Canadian law,
some U.S. garage door openers also feature a
"break".
Proceed as follows:
• If you live in Canada
• If you have difficulties programing the ga-
rage door opener (regardless of where you
live) when using the programing steps.
1. Press and hold one of buttons
䊊
2
to
䊊
4
on
the HomeLink®. After a short time, indi-
cator light
䊊
1
lights up yellow.
2. Release the button.
Indicator light
䊊
1
flashes yellow.
3. Press button
䊊
6
of the hand held trans-
mitter
䊊
5
for two seconds, then release it
for two seconds.
4. Press button
䊊
6
again for two seconds.
5. Repeat this sequence on button
䊊
6
of the
hand held transmitter
䊊
5
until indicator
light
䊊
1
lights up green.
When indicator light
䊊
1
lights up green:
programing is finished.
When indicator light
䊊
1
flashes green:
programing was successful. The next step
is to synchronize the rolling code.
6. Release button
䊊
6
of the hand held trans-
mitter
䊊
5
for the garage door drive.
If indicator light
䊊
1
lights up red: repeat
the programing process for the corre-
sponding button on the rear-view mirror.
When doing so, vary the distance be-
tween the hand held transmitter
䊊
5
and
the rear-view mirror.
The required distance between the hand
held transmitter
䊊
5
and the HomeLink®
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least 25
seconds before trying another position.
PROGRAMMING TROUBLE
DIAGNOSIS
If the HomeLink® does not quickly learn the
hand-held transmitter information:
• Check the transmitter frequency used by
garage door drive hand-held transmitter
䊊
5
and whether it is supported. The trans-
mitter frequency can usually be found on
the back of the garage door drive hand-
held transmitter. HomeLink® is compat-
ible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
• Replace the hand-held transmitter
䊊
5
bat-
teries with new batteries.
This increases the likelihood that the hand-
held transmitter
䊊
5
will transmit a strong
and precise signal to the HomeLink®.
• When programing, hold the hand-held
transmitter
䊊
5
at varying distances and
angles from the button which you are pro-
graming. Try various angles at a distance
between 2 and 12 inches (5 to 30 cm) or at
the same angle but at varying distances.
• If another hand-held transmitter is avail-
able for the same garage door drive, re-
peat the same programing steps with this
hand-held transmitter
䊊
5
. Before per-
forming these steps, make sure that new
batteries have been installed in the hand-
held transmitter
䊊
5
.
• Note that some hand-held transmitters
only transmit for a limited amount of time
(the indicator light on the hand-held trans-
mitter goes out). Press button
䊊
6
on re-
mote hand-held transmitter
䊊
5
again be-
fore transmission ends.
2-90 Instruments and controls
Loading ...
Loading ...
Loading ...