Loading ...
Loading ...
Loading ...
FEATURES OF YOUR HYUNDAIFEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAIFEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAI
1- 48
B922B03X-GAT
1. POWER ON-OFF/VOLUME
CONTROL KNOB
The radio unit may be operated when the ignition
key is in the "ACC" or "ON" position. The clock
will be displayed automatically, although the ra-
dio unit has gone out. Press the button to switch
the power on. The LCD shows the radio fre-
quency in the radio mode or the CD track indica-
tor in the CD mode. To switch the power off,
press the button again.
VOLUME Control
Rotate the knob clockwise to increase the vol-
ume and turn the knob counterclockwise to re-
duce the volume.
BALANCE Control
Pull and turn the control knob clockwise to em-
phasize right speaker sound. (Left speaker sound
will be attenuated) When the control knob is
turned counterclockwise, left speaker sound will
be emphasized. (Right speaker sound will be
attenuated)
2. FAD (Fader Control) Knob
Turn the control knob counterclockwise to em-
phasize front speaker sound. (Rear speaker
sound will be attenuated) When the control knob
is turned clockwise, rear speaker sound will be
emphasized. (Front speaker sound will be atten-
uated)
FM/AM
6. PRESET STATION SELECT Button
Six (6) stations for AM, FM and FM2 respectively
can be preset in the electronic memory circuit on
this unit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be pro-
grammed into the memory of the radio. Then, by
simply pressing the band select button and/or
one of the six station select buttons, you may
recall any of these stations instantly. To program
the stations, follow these steps:
o Press band selector to set the band for AM,
FM, and FM2.
o Select the desired station to be stored by
seek, scan or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
o Press the station select button for more than
two seconds. A select button indicator will
show in the display indicating which select
button you have depressed. The frequency
display will flash after it has been stored into
the memory. You should then release the
button, and proceed to program the next
desired station. A total of 18 stations can be
programmed by selecting one AM and one
FM station per button.
o When completed, any preset station may be
recalled by selecting AM, FM or FM2 band
and the appropriate station button.
3. BASS/TREBLE Control Knob
BASS Control Knob
Press to pop the knob out and turn to the left or
right for the desired bass tone.
TREBLE Control Knob
Further pull-lock position of popped-up knob.
Turn to the left or right for the desired treble tone.
4. BAND Selector
Pressing the button changes the AM, FM1
and FM2 bands. The mode selected is displayed
on LCD.
5. TUNE (Manual) Select Button
Press the (+) side or (-) side to increase or to
decrease the frequency. With the button held
down for 0.5 sec. or more, the stop signal (broad-
casting radio wave) is ignored and channel se-
lection continues.
SEEK Operation (Automatic Channel
Selection)
Press the TUNE select button 1 sec. or more,
and releasing will automatically tune the next
available station. When the (+) side is pressed
longer than 1 second and releasing will automat-
ically tune the next higher frequency and when
the (-) side is pressed longer than 1 second and
releasing will automatically tune the next lower
frequency.
Loading ...
Loading ...
Loading ...