Loading ...
Loading ...
Loading ...
FEATURES OF YOUR HYUNDAIFEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAIFEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAI
1- 12
After installation of the child restraint system, try
to move it in all directions to be sure the child
restraint system is securely installed.
If you need to tighten the belt, pull more webbing
toward the retractor. When you unbuckle the
seat belt and allow it to retract, the retractor will
automatically revert back to its normal seated
passenger emergency locking usage condition.
NOTE:
o Before installing the child restraint sys-
tem, read the instructions supplied by the
child restraint system manufacturer.
o If the seat belt does not operate as de-
scribed, have the system checked imme-
diately by your authorized Hyundai dealer.
WARNING:
Do not install any child restraint system in the
front passenger seat. Should an accident
occur and cause the passenger side airbag
to deploy, it could severely injure or kill an
infant or child seated in an infant or child
seat. Therefore, only use a child restraint
system in the rear seat of your vehicle.
o Since a safety belt or child restraint sys-
tem can become very hot if it is left in a
closed vehicle, be sure to check the seat
cover and buckles before placing a child
there.
o When the child restraint system is not in
use, fasten it with a safety belt so that it
will not be thrown forward in the case of a
sudden stop or an accident.
o Children who are too large to be in a child
restraint should sit in the rear seat and be
restrained with the available lap/shoulder
belts. Never allow children to ride in the
front passenger seat.
o Always make sure that the shoulder belt
portion of the outboard lap/shoulder belt
is positioned midway over the shoulder,
never across the neck. Moving the child
closer to the center of the vehicle may help
provide a good shoulder belt fit. The lap
belt portion of the lap/shoulder belt or the
center seat lap belt must always be posi-
tioned as low as possible on the child's
hips and as snug as possible.
o If the seat belt will not properly fit the
child, we recommend the use of an ap-
proved booster seat in the rear seat in
order to raise the child's seating height so
that the seat belt will properly fit the child.
o Never allow a child to stand up or kneel on
the seat.
o Never use an infant carrier or child safety
seat that "hooks" over a seatback; it may
not provide adequate security in an acci-
dent.
o Never allow a child to be held in a person's
arms while they are in a moving vehicle, as
this could result in serious injury to the
child in the event of an accident or a
sudden stop. Holding a child in a moving
vehicle does not provide the child with
any means of protection during an acci-
dent, even if the person holding the child
is wearing a seat belt.
B230G01A-GAT
Installation on Outboard Rear Seats
YR10400B
To install a child restraint system in the outboard
rear seats, extend the shoulder/lap belt from its
retractor. Install the child restraint system, buckle
the seat belt and allow the seat belt to take up any
slack. Make sure that the lap portion of the belt is
tight around the child restraint system and the
shoulder portion of the belt is positioned so that
it cannot interfere with the child's head or neck.
On outboard rear seats
Loading ...
Loading ...
Loading ...