LV-7280 User Manual

Loading ...

BLANK

POWER

INPUTIMAGE

ASPECT

INFO.

AUTO PC

BACK

BLANK

POWER

INPUTIMAGE

ASPECT

INFO.

AUTO PC

BACK

3. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

When you rst turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select

one of the 21 menu languages.

To select a menu language, follow these steps:

1. Use the or button to select one of the 21

languages for the menu.

2. Press the OK button to execute the selection.

After this has been done, you can proceed to the menu op-

eration.

If you want, you can select the menu language later. See

[Language]onpages49 and 60.

NOTE:Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamp

lightingisstabilized.

NOTE: If you turn on the projector immediately after the lamp is turned off or when the temperature is high, the fans runs with-

out displaying an image for some time and then the projector will display the image.

When the Lamp mode is set to Quiet, the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

• Iftheinternaltemperatureoftheprojectoristoohigh,theprojectorwillnotturnontoprotecttheinternalsystem.

Please wait for the projector's internal components to cool down.

• Whenthelampreachesitsendofusablelife,theprojectorwillnotturnon.Ifthishappens,replacethelamp.

• Ifthelampfailstolight,andiftheSTATUSindicatorashesonandoffinacycleofsixtimes,waitafullminute

and then turn on the power.

NOTE:TurningtheMainPowerSwitchOffthenBackOn

Allowaminimumof1secondbetweenturningoffthemainpowerswitchandturningitbackonagain.

Thesamewillbeappliedwhenapowerstripequippedwithaswitchandabreakerisused.

Failingtodosocouldresultinnopowertotheprojector.(Therewillbenostand-byLED)

Should this happen, unplug the power cord and plug it in again. Turn on the main power switch.

CAUTION:

The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator

is blinking green. Doing so could cause premature lamp failure.

Loading ...

User Manual - Page 34