Owner 's Manual - Page 91

For 2017 I-MIEV.

Loading ...
Loading ...
Loading ...
Child restraint systems
Seat and restraint systems 4-19
4
4. After the belt has retracted, tug on it. If
the belt is in the ALR function, you will
not be able to pull it out. If the webbing
can be pulled out from retractor, the ALR
function has not been activated and you
will need to repeat steps 3 and 4.
5. After confirming that the belt is locked,
grab the shoulder part of the belt near the
buckle and pull up to remove any slack
from the lap part of the belt allowing the
slack to feed into the retractor. Remember,
if the lap belt portion is not tight, the child
restraint system will not be secure. It may
help to put your weight on the child
restraint system and/or push on its seat-
back while pulling up on the belt (see
illustration).
6. Open the cover from the tether anchor
installation point by pulling it back with
your hand as illustrated below (6).
7. Latch the tether strap hook (A) of the
child restraint system to the tether anchor
(B) as illustrated below (7) and tighten the
top tether strap so it is securely fastened.
8. Before putting your child in the restraint,
push and pull the restraint in all directions
to be sure it is firmly secured. Do this
before each use. If the child restraint sys-
tem is not firmly secure, repeat steps 1
through 7.
9. To remove a child restraint system from
the vehicle and deactivate the ALR mode,
remove the child from the restraint.
Unlatch the buckle. Then remove the belt
from the restraint and let the belt fully
retract.
10. Reinstall the head restraint.
Refer to “Head restraints” on page 4-6.
N00407601615
Children who have outgrown a child restraint
system should be seated in the rear seat and
wear the seat belt. If the shoulder belt crosses
their face or neck, and/or the lap belt crosses
their stomach, a commercially available
If your child restraint system requires the use
of a tether strap, fasten the tether strap in
accordance with the following procedures.
WARNING
Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems. Under
no circumstances are they to be used for
adult seat belts, harnesses, for attaching
other items, or equipment to the vehicle.
Children who have outgrown
child restraint systems
BK0220401US.book 19 ペー 2015年6月3日 水曜日 午前7時42分
Loading ...
Loading ...
Loading ...