Loading ...
Loading ...
Loading ...
Coolant/Hot water heater fluid
Vehicle care and maintenance 9-5
9
1. Open the liftgate.
2. Peel off the Velcro fastener (A) to remove
the luggage room floor carpet (B).
3. Turn the 4 screws on the front and rear of
the electric motor unit room lid (C) coun-
terclockwise to loosen and remove them,
and then remove the electric motor unit
room lid (C).
4. Check the coolant level in the reservoir
(D).
While the motor is cold, the coolant level
must always be between the “F (FULL)”
and the “L (LOW)” marks. If necessary,
add coolant. Refer to “To add coolant” on
page 9-6.
5. Reinstall the electric motor unit room lid
and the luggage room floor carpet by fol-
lowing the removal procedures in reverse.
The reservoir (A) is located under the hood.
The room under the hood and the electric
motor unit room (located under the lug-
gage room carpet) can be very hot after
driving. Wait until they have cooled down.
Coolant
WARNING
NOTE
A heat insulating material is attached to the
luggage room floor carpet. To remove the
luggage floor carpet, grasp and lift up both
the carpet fabric and the heat insulating
material.
NOTE
When laying the electric motor unit room lid
on the ground, leave the underside of the lid
with the rubber surface facing up. If the
underside is facing downward debris and
other foreign material could get on the rub-
ber surface and prevent proper reinstallation
of the electric motor unit room lid.
WARNING
Never touch components inside the elec-
tric motor unit room except the reservoir
(D).
Hot water heater fluid
FULL
LOW
BK0220401US.book 5 ページ ２０１５年６月３日 水曜日 午前７時４２分
Loading ...
Loading ...
Loading ...