Loading ...
Loading ...
Loading ...
Tire repair kit
For emergencies 8-9
8
12. After injecting the sealant, securely fit the
valve remover (F) into the end of the filler
hose (K) to prevent sealant from leaking
from the empty bottle.
13. Pull out the compressor hose (L) from the
side of the tire compressor, and then
securely attach the hose to the tire valve
(E).
14. Place the compressor (M) with its air
pressure gauge (N) on top.
Pull out the compressor’s power cord (O),
insert the plug on the cord into the 12 V
power outlet (P), and then turn the electric
motor switch to the “ACC” position.
(Refer to “12V power outlet” on page
5-76.)
Turn ON the compressor switch (Q) and
inflate the tire to the specified pressure.
(Refer to “Tire inflation pressures” on
page 9-13.)
If there is a gap between the tire and
wheel, push the tread area toward the cen-
ter of the wheel to close the gap before
running the compressor.
15. Check and adjust the tire pressure with
reference to the air pressure gauge on the
compressor. If you overinflate the tire,
release air by loosening the hose’s end fit-
ting.
WARNING
Do not place your hand or fingers between
the tire and wheel while inflating the tire.
Your hand or fingers may become caught
between the tire and wheel.
CAUTION
The supplied compressor is designed only
for inflation of your vehicle tires.
The compressor is designed to run on a vehi-
cle’s 12 V power supply. Do not connect it to
any other power source.
The compressor is not waterproof. If you use
it in rain, make sure water does not get on it.
Any sand or dust sucked into the compressor
could make the compressor break down. Do
not place the compressor directly on any
sandy or dusty surface when using it.
Do not disassemble or modify the compres-
sor. Also, do not subject the air pressure
gauge to shock. It could malfunction.
BK0220401US.book 9 ページ ２０１５年６月３日 水曜日 午前７時４２分
Loading ...
Loading ...
Loading ...