Loading ...
Loading ...
Loading ...
MiEV Remote System
General information/Charging 3-53
3
The following
symbol blinks
when the power
supply/communi-
cation switch on
the MiEV Remote
is pressed.
ERROR sym-
bol
symbol
Blinks after about 1 sec-
ond.
Electrical noise source is present in the
vicinity of the MiEV Remote. (e.g.
personal computer)
Electrical noise source is present
between the vehicle and the MiEV
Remote.
Move away from the noise source.
Blinks after about 10
seconds.
The MiEV Remote antenna is not
extended.
Extend the MiEV Remote antenna to communicate.
Out of effective communication range.
(e.g. too far away from the vehicle, or
radio signal is interfered)
Move to the location where the system reaches the
effective communication range.
The electric motor switch is at the position
other than “LOCK” position.
Turn the electric motor switch to the “LOCK” posi-
tion.
Electrical noise source is present in the
vicinity of the vehicle.
Electrical noise source is present
between the vehicle and the MiEV
Remote.
Move away from the noise source.
12V starter battery is discharged. Charge or replace the 12V starter battery.
Refer to “Jump-starting” on page 8-2, “12V starter
battery” on page 11-6.
The below symbol blinks about 10 seconds
after the power/communication switch on the
MiEV Remote is pressed.
ERROR symbol
Some errors occur while the system is in
processing.
Press the power/communication switch again.
Phenomena Cause Remedy
BK0220401US.book 53 ページ ２０１５年６月３日 水曜日 午前７時４２分
Loading ...
Loading ...
Loading ...