Loading ...
Loading ...
Loading ...
High-Voltage components
3-34 General information/Charging
3
N01205700027
High voltage components and wiring cables
are located as shown in the figure below.
The charging indicator is
continuously blinking even
if the quick charge connec-
tor is not connected into the
quick charge port when you
start the electric motor unit
after quick charging.
Quick charging has not finished nor-
mally.
Perform quick charging again and finish it normally or contact a certified
i-MiEV dealer.
EV (Electric Vehicle) sys-
tem does not start after
quick charging.
The vehicle has a malfunction. Contact a certified i-MiEV dealer.
If you need to push the vehicle, turn the electric motor switch to the “ON”
position and move the selector lever to the “N”(NEUTRAL) position.
Symptom Possible cause Possible solution
High-Voltage components
WARNING
The EV (Electric Vehicle) system uses high
voltage up to DC 330 volt. The system can
be hot during and after starting and when
the vehicle is shut off. Be careful of both
the high voltage and the high temperature.
Follow the warning labels that are
attached to the vehicle.
Never touch, disassemble, remove or
replace high-voltage parts, exposed elec-
trical components, cables or connectors.
Failure to follow this instruction can
result in severe burns or electric shock
causing serious injury or death. High-volt-
age cables are colored orange. The vehicle
high voltage system has no user service-
able parts. Take your vehicle to a Certified
i-MiEV dealer for any necessary mainte-
nance.
Always assume the high voltage battery
and associated components are energized
and fully charged.
WARNING
1- Regular charge port
2- MCU
3- Main drive lithium-ion battery
4- Heater
5- Air conditioner compressor
6- High voltage connector
7- Service plug
8- Electric motor (Electric motor unit)
9- On board charger/DC-DC converter
BK0220401US.book 34 ページ ２０１５年６月３日 水曜日 午前７時４２分
Loading ...
Loading ...
Loading ...