Loading ...
Loading ...
Loading ...
Chapter 10
90
Replacing the
Time/Date Battery
10
A time/date battery is provided in order to
maintain the settings for the internal clock.
The battery will be consumed even if the
printer is not used for a long period of time.
a Press and hold the (Power) button to
turn the printer off, and then disconnect
the printer from the AC power outlet. If
the rechargeable Li-ion battery
(optional) is installed, remove the
rechargeable battery.
b Press the cover release lever on either
side and lift up to open the RD Roll
compartment top cover.
c Using a coin or similar object, slowly turn
the time/date battery cover in the
direction of the arrow on the battery
cover until it stops, and then remove the
time/date battery cover.
d Remove the battery.
As shown below, press part A of the
battery to release it so that it can easily
be removed.
e Install the new battery.
Only use recommended batteries in
the printer. Other batteries may
cause damage to the printer.
Dispose of the battery at an
appropriate collection point, not in
the general waste stream. In
addition, be sure to observe all
applicable federal, state, and local
regulations.
When storing or discarding the
battery, wrap it (for example with
cellophane tape), to prevent it from
short-circuiting.
(Battery insulation example)
1 Cellophane tape
2 Time/date battery
We recommend replacing the
battery every two years.
If the clock is reset while power is
supplied to the printer, replace this
battery. When replacing the lithium
battery, purchase a CR2032 battery
(recommended manufacturers:
Hitachi Maxell, Ltd., FDK
Corporation, Panasonic
Corporation, Sony Corporation,
Toshiba Corporation and VARTA
Microbattery Inc.).
1
2
If the time/date battery cover is forcibly
turned past the stop position, it may be
damaged.
Be sure to insert the new battery with
the + and – sides facing the correct
direction.
Loading ...
Loading ...
Loading ...