FDR-AX700 Help Guide

Loading ...

Hold the S&Q button down for about 1 second and change the value with / / / /SET button, then press / / /

/SET button to enter.

To cancel the Super Slow Motion recording

Press the S&Q button or MENU button during standby.

Note

The supported memory cards vary depending on the file format.

When recording with Super Slow Motion recording, the camcorder may continue recording for some time (approximately 3

minutes at most) after you press the START/STOP button to stop recording. Do not operate your camcorder while the [REC]

indicator is flashing on the LCD monitor. Wait until it turns to [STBY].

After you press the START/STOP button to stop recording, the camcorder continues recording until it completes writing of the

minimum unit of data (0.5 seconds of replay time).

The Super Slow Motion recording is available only when full auto mode is off. Note that iris, gain, focus, and shutter speed are

fixed to manual.

When [960fps] ([1000fps]) is selected in [FRAME RATE], the image to be displayed and recorded shifts approximately 1.35 times

toward the telephoto side.

When [480fps], [960fps] ([500fps], [1000fps]) is selected in [FRAME RATE], the image quality is deteriorated compared with the

image with normal recording.

If you adjust the gain or shutter speed, or change the white balance, the image on the LCD screen changes. However, the

camera setting at the time the recording ends is reflected in the recorded image.

To change the frame rate setting, first stop recording.

The time code is recorded in [REC RUN] mode.

The Super Slow Motion recording mode is canceled automatically when the camcorder is turned off, but the frame rate setting is

retained.

Flicker adjustment is not available.

You cannot record audio during the Super Slow Motion recording.

Auto focus function is not available.

You cannot select a shutter speed value slower than the frame rate.

[SUPER SLOW MOTION] is disabled when [FILE FORMAT] is set to [XAVC S 4K] or [AVCHD].

[SUPER SLOW MOTION] is disabled when the AUTO/MANUAL switch is set to AUTO.

Help Guide - Page 94