Loading ...
Loading ...
Loading ...
Figure 5-1 Inializaon Jumper Cap
2.
Disconnect the power and reboot the device. The device buzzer buzzes a long beep.
3.
When the beep stopped, plug the jumper cap back.
4.
Disconnect the power and power on the device again.
Cauon
The inializaon of the device will restore all the parameters to the default seng and all the
device events are deleted.
Note
Make sure no persons are in the lane when powering on the device.
5.3 Switch to RS-485/RS-232 Mode
Take the Serial Port 4 and on the access control board as an example. If the Jumper cap's posion is
like the picture displayed below. (The black part is the jumper cap.) The serial port is in RS-485
communicaon mode.
DS-K3G501SX Series Tripod Turnsle User Manual
25
Loading ...
Loading ...
Loading ...