Loading ...
Loading ...
Loading ...
1. At the printer control panel, rotate the control dial to select the Menu option, and then press the
dial.
2. Rotate the dial to select Settings, and then press the dial.
3. Rotate the dial to select Network , and then press the dial to open the network settings list.
4. Rotate the dial to select one of the following menus, and then press the dial.
● Ethernet Settings (for a wired network)
● Wireless Settings (for a wireless network)
5. Adjust the settings as needed.
Link speed and duplex settings
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the printer in automatic mode. Incorrect changes to the link speed and duplex
settings might prevent the printer from communicating with other network devices. If you need to
make changes, use the printer control panel.
NOTE: This information applies only to Ethernet (wired) networks. It does not apply to wireless
networks.
NOTE: The printer setting must match the setting for the network device (a network hub, switch,
gateway, router, or computer).
NOTE: Making changes to these settings causes the printer to turn off and then on. Make changes
only when the printer is idle.
1. At the printer control panel, rotate the control dial to select the Menu option, and then press the
dial.
2. Rotate the dial to select Settings, and then press the dial.
3. Rotate and press the dial to open the following menus:
a. Network Settings
b. Ethernet Settings
c. Link Speed
4. Rotate the dial to select one of the following options:
Table 5-2
Link Speed settings
Setting Description
10 Mb Half 10 Mbps, half-duplex operation
10 Mb Full 10 Mbps, full-duplex operation
100 Mb Half 100 Mbps, half-duplex operation
100 Mb Full 100 Mbps, full-duplex operation
1000 Mb Full 1000 Mbps, full-duplex operation
54 Chapter 5 Manage the printer
Loading ...
Loading ...
Loading ...