Loading ...
Loading ...
Loading ...
EN
24
www.mythinkcar.com
THINKSCAN Max2
This function can set the sunroof lock off , close in rain, memory function of sliding / tilting
sunroof, outside temperature threshold, etc.
5.2.15 EGR Adaption
This function is used to learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned
or replaced.
5.2.16 Gear Learning
The crankshaft position sensor learns crankshaft tooth machining tolerance and saves
to the computer to more accurately diagnose engine misfires. If tooth learning is not
performed for a car equipped with Delphi engine, the MIL turns on after the engine is
started. The diagnostic device detects the DTC P1336 'tooth not learned'. In this case, you
must use the diagnostic device to perform tooth learning for the car. After tooth learning is
successful, the MIL turns off .
After the engine ECU, crankshaft position sensor, or crankshaft fl ywheel is replaced, or the
DTC 'tooth not learned' is present, tooth learning must be performed.
5.2.17 ODO Reset
a) ODO reset is to copy, write, or rewrite the value of kilometers in the chip of odometer
by using a car diagnostic computer and data cable, so that the odometer shows the actual
mileage.
b) Usually when the mileage is not correct due to the damaged vehicle speed sensor or
odometer failure, it is necessary to do ODO reset after maintenance.
5.2.18 Airbag Reset
This function resets the airbag data to clear the airbag collision fault indicator. When the
vehicle collides and the airbag deploys, the corresponding fault code of the collision data
appears, the airbag indicator lights up, and the fault code cannot be cleared. Since the
data inside the airbag computer is disposable, it is required that all new accessories must
be replaced, but after performing this function, the data of the airbag computer can be
recovered and the fault code can be cleared, the airbag light will go out, and the airbag
computer can continue to use.
5.2.19 Transport Mode
In order to reduce power consumption, the following functions may be disabled, including
limiting the vehicle speed, not waking up the door opening network, and disabling the
remote control key, etc. At this time, the transport mode needs to be deactivated to restore
the vehicle to normal.
Loading ...
Loading ...
Loading ...