Tripp Lite B093-004-2E4U-V Owner's Manual

Loading ...

3. System Conﬁguration

3.6.5 Static Routes

Firmware 3.4 and later support static routes, which provide a quick way to route data from one subnet to a different subnet.

You can hard code a path that speciﬁes to the console server/router to get to a certain subnet by using a certain path.

This may be useful for remotely accessing various subnets at a remote site when being accessed using the cellular OOB

connection.

To add to the static route to the system’s route table:

• Select the Route Settings tab on the System: IP General Settings menu.

• Enter a meaningful Route Name for the route.

• In the Destination Network/Host ﬁeld, enter the IP address of the destination network/host that the route provides access

to.

• Enter a value in the Destination netmask ﬁeld that identiﬁes the destination network or host. Any number between 0 and

32 can be used. A subnet mask of 32 identiﬁes a host route.

• Enter Route Gateway with the IP address of a router that will route packets to the destination network. This ﬁeld may be

left blank.

• Select the Interface to use to reach the destination. This ﬁeld may be left as None.

• Enter a value in the Metric ﬁeld that represents the metric of this connection. This generally has to be set only if two or

more routes conﬂict or have overlapping targets. Any number equal to or greater than 0.

• Click Apply.

Note: The route details page provides a list of network interfaces and modems to which a route can be bound. In the case of a modem, the

route will be attached to any dial-up session, which is established via that device. A route can be speciﬁed with a gateway, an interface or

both. If the speciﬁed interface is not active for whatever reason, then the routes conﬁgured for that interface will not be active.

3.7 Conﬁguration over DHCP (ZTP)

Conﬁguration-over-DHCP is available for all Tripp Lite console managers running ﬁrmware release 3.16 or later. With this

feature, Tripp Lite devices can be provisioned during their initial boot from a DHCP server. Provisioning on untrusted networks

can be facilitated by providing keys on a USB ﬂash drive.

Preparation

The typical steps for conﬁguration over a trusted network are:

• Manually conﬁgure a same-model Tripp Lite device.

• Save its conﬁguration as a backup (.opg) ﬁle.

• Select System > Conﬁguration Backup > Remote Backup.

• Click Save Backup.

Loading ...

Tripp Lite B093-004-2E4U-V 4-Port Console Server with 4G LTE Cellular Gateway, Dual GbE NIC, 4Gb Flash and Dual SIM