Tripp Lite B093-004-2E4U-V Owner's Manual

Loading ...

121

6. SSH Tunnels and SDT Connector

• On the Network Connection screen, select TCP/IP, then click Properties.

• Select Specify TCP/IP addresses on the Incoming TCP/IP Properties screen, then select TCP/IP. Assign a From: and a

To: TCP/IP address. Click Next.

Note: You can choose any TCP/IP addresses as long as they are not used anywhere else on your network. The From: address will be

assigned to the Windows XP/2003 computer and the To: address will be used by the console server. For simplicity, use the following IP

address:

From: 169.134.13.1

To: 169.134.13.2

Alternately, you can set the advanced connection and access on the Windows computer to use the console server defaults:

• Specify 10.233.111.254 as the From: address.

• Select Allow calling computer to specify its own address.

Additionally, you can use the console server default username and password when you set up the new Remote Desktop User. In doing so,

the user is granted permission to use the advanced connection to access the Windows computer:

• The console server default username is portXX, where XX is the serial port number on the console server.

• The default Password is portXX.

To use the defaults for a RDP connection to the serial port 2 on the console server, you will need to set up a Windows user named port02.

• When the PPP connection has been set up, a network icon will appear in the Windows task bar.

Note: The above notes describe setting up an incoming connection for Windows XP. The steps are similar for later versions with some slight

differences:

• You need to check the box for Always allow directly connected devices.

• Also, the option for to Set up an advanced connection is not available in Windows 2003 if RRAS is conﬁgured. If RRAS has been

conﬁgured, it is a simply task to enable the null modem connection for the dial-in conﬁguration.

For earlier versions of Windows, follow the steps in the For Windows XP and 2003 computers section. To get to the Make

New Connection button:

• For Windows 2000, click Start and select Settings. At the Dial-Up Networking Folder, click Network and Dial-up

Connections, then click Make New Connection. You may need to ﬁrst set up connection over the COM port using

Connect directly to another computer before proceeding to Set up an advanced connection.

• For Windows 98, double-click My Computer on the Desktop, then open Dial-Up Networking and double-click.

Loading ...

Tripp Lite B093-004-2E4U-V 4-Port Console Server with 4G LTE Cellular Gateway, Dual GbE NIC, 4Gb Flash and Dual SIM