Loading ...
Loading ...
Loading ...
TROUBLE SHOOTING CHART (Con't.)
PROBABLE CAUSETROUBLE
Motor stalls (resulting in
blown fuses or tripped
circuit breakers).
Frequent opening of
fuses or circuit breakers,
Brake fails to work.
Kickbacks when ripping,
1. Starting relay not operating.
2. Voltage too low to permit
motor to reach operating speed
3, Fuses or circuit breakers do not
have sufficient capacity.
I 1. Motor overloaded.
2. Fuses or circuit breakers do notl
have sufficient capacity.
3. Starting relay not operating
(motor does not reach normal
speed.)
1. Brake assembly "hums"
excessively or "chatters."
2. Failure of brake coil
(short circuit or "open").
1. Not using spreader,
2. Blade not parallel to
rip fence.
3. Failure to push wood all the
way past saw blade.
4. Warped wood.
5. Anti-kickback pawls
not working properly.
REMEDY
1. Replace relay.
2, Correct the low line voltage condition.
3. Replace fuses or circuit breakers with proper capacity
units.
1. Reduce motor load.
2. Replace fuses or circuit breakers.
3. Replace relay.
1. Replace the brake coil.
2. a. Check for foreign particles between the brake
shoe inside diameter and shoulder of brake disc,
b. Check for 0.020-inch clearance between brake
shoe and brake disk. (Clearance is probably
less than 0.020-inch.)
1.
2.
3.
4.
5.
Use spreader.
Position the saw for ripping as described in applicable
paragraphs under "Basic Saw Operations".
Push wood all the way past saw blade. (Refer to
applicable paragraphs under "Basic Saw Operations".)
Use caution. (Refer to applicable paragraphs under
"Basic Saw Operations".)
Check for proper adjustment. Clean out any dust
accumulations and apply a drop of oil around the pin.
Sharpen the teeth on pawls with a file.
RECOMMENDED ACCESSSORI ES
IN CANADA, SEE YOUR LOCAL SIMPSONS-SEARS STORE
OR CATALOG FOR ACCESSORY SELECTION AND NUMBERS
ITEM CAT.NO.
Key Chuck .............................. 9-2980
Molding Head Guard -- 8-inch ............... 9-29523
Rotary Surface Planer Carbide Tip .......... 9-29513
Sanding Wheel - 8-inch .................... 9-2274
Sanding Wheel -- 10-inch ................... 9-22723
Dust Collector ........................... 9-16998
Taper Jig ................................ 9-3233
Satin Cut Dado -- 7-inch ..................... 9-3257
Satin Cut Dado -- B-inch ..................... 9-3253
Steel Legs .............................. 9-22238
ITEM CAT.NO.
Dust Collector ........................... 9-29517
Heavy Duty Dado - 8-inch .................. 9-32473
Molding Head Single Cutter .................. 9-3215
Molding Head Three Cutter .................. 9-3217
Sanding Drum 3-inch .................... 9-25246
Caster Set ............................... 9-22201
Leg Set ................................. 9-22211
Power Tool Know How Handbook
Radial Saw .............................. 9-2917
The above recommended accessories are current and were available at the time this manual was printed.
27
Loading ...
Loading ...
Loading ...