Craftsman 11323301 12" Radial Arm Saw

Owner's Manual - Page 20

For 11323301.

PDF File Manual, 36 pages, Read Online | Download pdf file

11323301 photo
Loading ...
Loading ...
Loading ...
basic saw operations
SWIVEL LATCH
PIN KNOB
ARM LATCH
HANDLE
Out-Ripping (See figure 58.) The radial arm and bevel are
indexed at 0° and locked, but the yoke is turned 90-degrees
in a counterclockwise direction (viewed from above), from
the crosscut position. When standing in front of the saw,
blade would be rotating clockwise. After positioning the
guard and anti-kickback mechanism the workpiece is fed
from the left-hand side of the saw, as shown in figure 58.
The "Out-Rip" scale is on the left-hand side of radial arm.
Figure 58
Figure 59
OPERATION No. 6- BEVEL RIPPING
Bevel ripping is either in-ripping or out-ripping as described
above, except the saw blade is tilted out of perpendicular to
the saw table surface. Figure 59 shows a typical bevel
out-ripping operation. The radial arm is indexed at 0° and
locked, the bevel is set to the desired bevel angle and the
yoke is positioned for in-ripping (saw blade at rear) or
out-ripping (saw blade at front), as required. All
requirements and observations applicable to normal ripping
operations also apply to bevel ripping.
DADOING
For best results and to avoid excessive load on the motor,
NEVER CUT A 13/16" WIDE DADO, DEEPER THAN
3/4" IN ONE PASS.
20
Loading ...
Loading ...
Loading ...