Loading ...
Loading ...
Loading ...
User Guide 134
Configuring DDM (Only for Certain Devices) DDM Configuration
2.1.2 Configuring the Threshold
Note:
The value of threshold parameters should conform to the following rule: High Alarm ≥ High Warning
≥ Low Warning ≥ Low Alarm.
Choose the menu L2 FEATURES > Switching > DDM > Threshold Config to load the
following page.
â– Configuring the Temperature Threshold
Figure 2-2 Configure Temperature Threshold
Follow these steps to configure DDM‘s temperature threshold:
1) In the Temperature table, select one or more SFP ports to configure temperature
threshold of the SFP ports.
High Alarm Specify the high temperature threshold for the alarm. When the operating
parameter rises above this value, action associated with the alarm will be taken.
The valid values are from -128 to 127.996.
Low Alarm Specify the low temperature threshold for the alarm. When the operating
parameter falls below this value, action associated with the alarm will be taken.
The valid values are from -128 to 127.996.
High Warning Specify the high temperature threshold for the warning. When the operating
parameter rises above this value, action associated with the warning will be taken.
The valid values are from -128 to 127.996.
Low Warning Specify the low temperature threshold for the warning. When the operating
parameter falls below this value, action associated with the warning will be taken.
The valid values are from -128 to 127.996.
LAG Displays the LAG number which the port belongs to.
2) Click Apply.
Loading ...
Loading ...
Loading ...