Loading ...
Loading ...
Loading ...
User Guide 1000
Configuring OAM (Only for Certain Devices) Ethernet OAM Configurations
Maximum
OAMPDU
Displays the maximum size of OAMPDU.
Remote
Loopback
Displays whether the remote entity supports Remote Loopback.
Unidirection Displays whether the remote entity supports Unidirection.
Link Monitoring Displays whether the remote entity supports Link Monitoring.
Variable Request Displays whether the remote entity supports Variable Request.
PDU Revision Displays the PDU Revision of the remote entity.
Vendor
Information
Displays the vendor information of the remote entity.
2.2 Using the CLI
2.2.1 Enabling OAM and Configuring OAM Mode
Follow these steps to enable OAM and configure OAM mode on the port:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
}
Enter interface configuration mode.
Step 3 ethernet-oam
Enable OAM on the port.
Step 4 ethernet-oam mode { passive | active }
Configure the OAM mode of the port.
passive:
Specify the OAM mode as passive. The port in this mode cannot initiate OAM
connection or send Loopback Control OAMPDU.
active:
Specify the OAM mode as active. The port in this mode can initiate OAM connection.
It is the default setting.
Note
: OAM connection cannot be established between two ports in passive mode. Make
sure that at least one side is in active mode.
Step 5 show ethernet-oam configuration [ interface fastEthernet {
port
|
port-list
} |
interface
gigabitEthernet {
port
|
port-list
} | ten-gigabitEthernet {
port
|
port-list
} ]
Verify the OAM configuration.
Loading ...
Loading ...
Loading ...