Loading ...
Loading ...
Loading ...
16
If mowing is uneven, check the tyre pressure.
please contact your Dealer to adjust the align-
ment of the cutting-means assembly.
6.4.2 Replacing the wheels (Fig. 6.6)
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels are held by a snap ring (1) which
can be removed with a screwdriver.
NOTE If you have to replace one or both rear
wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on
the contrary, you must adjust the cutting-means
assembly alignment to prevent uneven mowing.
IMPORTANT Before remounting the wheel,
apply grease to the axle. Put the snap ring (1)
and shoulder washer (2) back in place.
6.4.3 Repairing or replacing tyres
All puncture repairs or replacements will have to
be carried out by a tyre repair expert in accord-
ance with the methods for the kind of tyre used.
6.4.4 Replacing a fuse (Fig. 6.7)
– 10 A fuse = protects the main and power cir-
cuits of the electronic circuit board. When it
blows, the machine stops and the dashboard
– 25 A fuse = protects the battery recharge cir-
cuit. When it blows, the battery gradually runs
down and the machine will have problems
starting.
With Honda engine
– 10 A fuse = protects the main and pow-
er circuits of the electronic circuit board.
When it blows, the machine stops and the
– 25 A fuse = protects the battery recharge
circuit. When it blows, the battery gradu-
ally runs out and the machine will have
problems starting.
– T6.3 A (delayed) fuse (2) = protects the
main and power circuits of the electronic
circuit board. When it blows, the machine
The fuse capacity is indicated on the fuse.
IMPORTANT A blown fuse must always be
replaced by one of the same type and ampere
rating, and never with one of another rating.
If you are unable to understand why it has
blown, contact Your Dealer.
6.4.5
-
stalled in the bulb holder which can be taken out
by turning it anti-clockwise with pliers.
6.4.6 Removing, replacing and
reassembling of cutting means
WARNING! Always wear strong protec-
tive gloves to handle the cutting means.
WARNING! Always replace damaged or
bent cutting means; never attempt to repair
them! ALWAYS USE ORIGINAL CUTTING
MEANS!
Only cutting means bearing the code indicated
in the table on page ii must be used on this ma-
chine.
Given product evolution, the above mentioned
cutting means may be replaced in time with oth-
ers having similar interchangeable and operat-
ing safety features.
Loading ...
Loading ...
Loading ...