Mountfield MTF 72H Petrol garden Tractor lawn rider sports a STIGA ST 350 352cc engine

Translation of the original instruction - Page 67

For MTF 72H. Also, The document are for others Mountfield models: F 72 FL, F 72 FL HYDRO

PDF File Manual, 118 pages, Read Online | Download pdf file

MTF 72H photo
Loading ...
Loading ...
Loading ...
12
gage the cutting means and stop the engine;
remove the grass catcher;
remove the grass cuttings; you can reach
them from the channel discharge opening.
WARNING! This job must only be per-
formed with the engine turned off.
5.4.8 End of mowing

cutting means, reduce the engine speed and
ride the machine with the cutting-means assem-
bly in the highest position.
5.4.9 End of work
Stop the machine, put the accelerator lever in

putting the ignition key into the «OFF» position.
When the engine has stopped, close the fuel

WARNING! To avoid backfire, put the
accelerator in the «SLOW» position for 20
seconds before stopping the engine.
IMPORTANT To keep the battery charged,
do not leave the ignition key in the «ON» position
when the engine is not running.
5.4.10 Cleaning the machine
After each mowing session, clean the outside
of the machine, empty the grass catcher and
shake it to remove residual grass and earth.
Clean the plastic parts of the body with a damp
sponge using water and detergent, taking care
not to wet the engine, the electrical parts or the
electronic circuit board located under the dash-
board.
IMPORTANT Never use hose-nozzles or
harsh detergents for cleaning the body and en-
gine!
WARNING! Do not let debris and dried
grass accumulate in the upper part of the
cutting-means assembly in order to maintain
maximum machine efficiency and safety
levels.
After each use, clean the cutting-means as-
sembly thoroughly to remove any grass remains
or debris.
WARNING! Wear eye protection and
keep people or animals away from the sur-
rounding area when cleaning the cutting-
means assembly.
a) When washing the inside of the cutting-
means assembly and the collector channel, the

 
the operator seated;
the cutting-means assembly in position «1»;
the engine running;
the transmission in neutral;
the cutting means engaged.

run water through it. Engage the cutting means
and allow it to run idle for a few minutes (Fig.
5.10).
Now remove the grass catcher, empty and rinse

b) To clean the upper part of the cutting-
means assembly:
lower the cutting-means assembly completely
(position «1»);
blow a jet of compressed air to remove any
remains of grass (Fig. 5.11).
5.4.11 Storage and inactivity for long
periods
If you intend not to use the machine for a long
period (more than 1 month), disconnect the
battery cables and follow the instructions in the
engine instruction manual.
Empty the fuel tank by disconnecting the tube
-
lect the fuel in a suitable container (Fig. 5.12).
Reconnect the tube (1) making sure you position
the clamp properly.
Put the machine away in a dry, sheltered place
and preferably covered with a cloth (see 8.5).
IMPORTANT The battery must be kept in a
cool and dry place. Before a long storage period
(more than 1 month), always charge the bat-
tery, and then recharge before using again (see
6.3.3).
The next time the machine is used, check that
there are no fuel leaks from the tubes, fuel stop-
cock or carburettor.
5.4.12 Circuit board protection device
The electronic circuit board has a self-resetting
protector which breaks the circuit if there is a
fault in the electrical system. This will stop the

The circuit automatically resets after a few sec-
onds but the cause of the fault should be ascer-
tained and dealt with to avoid reactivating the
protection device.
Loading ...
Loading ...
Loading ...