Loading ...
Loading ...
Loading ...
55
Figure 4-32
Step 2
Configure TCP/IP parameter, refer to Table 4-12.
Parameter
Function
Host Name
It is to set current host device name. It supports max 15
characters.
Ethernet Card
Please select the Ethernet port. Default is wired.
Please note you can modify the default Ethernet card if there is
more than one card. .
Please note the device needs to reboot to activate the new
setup once you modify the default setup.
Mode
There are two modes: static mode and the DHCP mode. Select
DHCP mode, it auto searches IP, and you cannot set IP/subnet
mask/gateway. Select static mode, you must manually set
IP/subnet mask/gateway.
Mac Address
It is to display device Mac address.
IP Version
It is to select IP version. IPV4 or IPV6.
You can access the IP address of these two versions.
IP Address
Please use the keyboard to input the corresponding number to
modify the IP address and then set the corresponding subnet
mask and the default gateway.
Subnet mask
It has to set according to the actual situation, the prefix of
subnet is number, input from 1 to 255, the prefix of subnet
identifies a specific network link, and usually it includes a
layering structure.
Loading ...
Loading ...
Loading ...