Loading ...
Loading ...
Loading ...
ioubleshooting
PROBLEM POSSIBLE CAUSE WHAT TO DO
Crust edge Filling requires more baking Shield edge with foil.
browns before time than crust
pie is done
The display is There has been a power Reset the clock. (See page 25.)
showing "PF" failure.
A letter
followed by the
number shows
on the display
(for example
"E3", "F1 ")
The display is
showing "F5"
and "E3"
Press CANCEL/OFF. If the code
does not disappear, call for service.
(See "Requesting Assistance or
Service" on pages 64-65.)
The power cord is not
properly grounded.
Make sure the power cord is plugged
into a mating 3-prong ground type
outlet. If the "F5" and "E3" code
appears again, call a qualified
electrician to verify that the outlet is
properly grounded. See Installation
Instructions.
The display is The oven is in the "Convect Refer to section "Using Convect Full
showing "CF" full meal" mode. Meal".
The key pads do Pads not touched long Hold down the pad a short time, and
not operate enough, or not enough time allow a short time between each pad
between each pad pressed, entry.
The Control Lock has been
set.
Turn off the Control Lock by opening
the oven door, pressing and holding
the Control Lock pad (Number Pad
3) for 5 seconds. (See "Using the
control lock" on page 21 .)
The Sabbath mode has
been set. ("SAb" appears on
the display.
Turn off the Sabbath mode by open-
ing the oven door, waiting up to 15
seconds, and pressing and holding
Number Pad 6 for 5 seconds.
The range is not properly
grounded.
Call an electrician to make sure the
outlet is well grounded. If it is well
grounded, and the key pads still do
not operate, call a service technician.
If none of these items was causing your problem, see "Requesting Assistance or Service" on page 64
or 65.
63
Loading ...
Loading ...
Loading ...