Loading ...
Loading ...
Loading ...
9 Philips · NeoPix 320
Prepare the remote control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
• When using a remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on and set up the
projector
Power on/off the projector
• To turn on the projector, press on the
projector/remote control. The power LED
on the projector turns from red to white.
• To turn off the projector, press and hold
on the projector/remote control for 2
seconds or press this button twice. The
projector enters standby mode and its
power LED turns from white to red.
• To fully shut down the projector, disconnect
the power cable from the electrical socket.
Image focus adjustment
To adjust the image focus (sharpness), turn
the focus adjustment knob attached to the
projection lens.
Tip: If you change the projection distance later,
you'll need to adjust the image focus again.
Screen size adjustment
The projection screen size (or size of images) is
determined by the distance between the lens
of the projector and the projection surface.
This projector has a recommended projection
distance of 244 cm (96"), and thus creates a
maximum screen size of 80" (203 cm). The
minimum distance from the projection surface
is 120 cm (47.2").
Digital zooming
You can use the digital zooming function to
reduce the screen size.
1 From the home screen, open the Quick
Settings panel by pressing on the
projector/remote control one or more times.
Then select Digital Zoom.
2 Press / to adjust the screen size. You
can scale down the screen to up to 60% of
its full size.
Loading ...
Loading ...
Loading ...