Loading ...
Loading ...
Loading ...
Attach Elevation Handwheel
1. From loose parts bag, find one (1) screw 10-32 x
1/2 and one (1) external Iockwasher. Install
handwheel to front of base as illustrated.
MOUNTING MOTOR
1. Remove the blade guard. Locate the arbor
wrenches and remove the blade.
CAUTION: 13o not attempt to mount the motor until
the blade guard and blade have been removed.
2. Elevatethe arm approximately 2 inches to remove
shipping pad.
3. Using a 3/4 socket remove 1/2-13 lock nut and
I/2" flat washer from motor pivot support.
4. Slide motor on motor pivot support until motor is
firmly seated on support as illustrated.
5. Re-install the flat washer and lock nut and
tighten until snug with 3/4" socket.
WARNING: DO NOT OVER TIGHTEN LOCKNUT.
To insure proper function of the bevel lock, move the
bevel lock handle while tightening the Iocknut.
Adjust according to Step 6.
[
_-
ELEVATION
HANDWHEEL
NOTE: Make sure bevel encoder lines up with
actuator on top of motor. Bevel encoder cord should
be positioned between actuator on motor plate.
Slide encoder to top of scale if adjustment is needed.
6. Push bevel lock handlel to left side to lock.
NOTE: Bevel lock handle should not contact extreme
left side of yoke when in locked position. If bevel
lock handle is permitted to contact yoke the following
adjustment is required.
a. Unlock bevel lock handle and tighten motor
Iocknut. Recheck bevel lock handle position (see
illustration).
b. Repeat adjustment if necessary. Do not over
tighten or motor will not index.
c. Locate yoke plug from loose parts bag. Make
sure bevel lock handle is locked and then snap
plug in place.
25
Loading ...
Loading ...
Loading ...