Loading ...
Loading ...
Loading ...
6. Locate the twelve (12) stand slide brackets,
twenty-four (24) truss head bolts, Iockwashers
and hex nuts. Assemble the stand slide brackets
on the rear supports and inside of the side panels
in holes as illustrated. Assemble the stand slide
brackets on the center and rear supports in holes
as illustrated starting at the top.
The rear mounting hole in the stand slide bracket
is slightly enlarged and must be mounted to the
rear support for stand slide stops to work. Tighten
nuts securely.
o_
TOp
7. Locate the twelve (12) center slide brackets and
the two (2) lubrication packets. Lubricate upper
& lower channel on all twelve (12) center slide
brackets,
NOTE: In order for drawer stops to work, the center
slide bracket must be assembled as illustrated.
Failure to do so may result in drawer sliding off slide
brackets.
8. Insert center slide brackets into the stand slide
brackets. Center slide brackets should snap over
front stop when pushed on stand slide bracket.
CABINET SLIDE BRACKETS STOP TO THIS SIDE
REAR STOP
DRAWER STOP TO THIS SIDE
9. Locate the metal drawer, drawer fronts and the
bag of drawer front push-in type fasteners. Slide
drawer fronts onto appropriate size drawer. Make
sure the drawer front tabs engage the metal
drawer edges. Align holes and install push-in
type fasteners to assemble front to metal drawer.
Be sure all fasteners clamp the drawer front
firmly to the metal drawer.
10. Set drawer assemblies aside until called for on
page 24.
/
/
18
Loading ...
Loading ...
Loading ...