Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
52
Before You Begin Programming
HomeLink
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accu-
rate transmission of the radio-frequency
s
ignal it
is recommended that a new battery
be placed in the hand-held transmitter of the
device that is being programmed to the
HomeLink system.
To erase the channels, place the ignition in
the ON/RU
N position, and push and hold the
two outside HomeLink buttons (I and III) for
up to 20 seconds or until the orange indi
-
cator flashes.
NOTE:
Erasing all channels should only be
performed when programming HomeLink
for the first time. Do not erase channels
when programming additional buttons.
If you have any problems, or require assis-
tance, please call toll-free
1-800-355
-3515 or, on the Internet at
HomeLink.com for information or assis-
tance.
Programming A Rolling Code
For programming garage door openers that
were manufactured after 1995. These
garage door openers can be identified by the
“LEARN” or “TRAIN” button located where
the hanging antenna is attached to the
garage door opener.
NOTE:
It is NOT the button that is normally used to
open and
close the door. The name and color
of the button may vary by manufacturer.
1. Place the ignition in the ON/RUN posi-
tion.
2. Pl
ace the hand-held transmitter 1 to
3 inches
(3 to 8 cm) away from the
HomeLink
button you wish to program
while keeping the HomeLink indicator
light in view.
3. Push and hold the HomeLink button you
want to
program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and
observe
the indicator light. The Home-
Link indicator will flash slowly and then
r
apidly a
fter HomeLink has received the
frequency signal from the hand-held
transmitter. Release both buttons after
the indicator light changes from slow to
rapid.
5. At the garage door opener motor (in the
garage),
locate the “LEARN” or
“TRAINING” button. This can usually be
found where the hanging antenna wire is
attached to the garage door opener/
device motor. Firmly push and release
the “LEARN” or “TRAINING” button. On
some garage door openers/devices there
may be a light that blinks when the
garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
n
ext step
after the LEARN button has been
pushed.
6. Return to the vehicle and push the
programm
ed HomeLink button twice
(holding the button for two seconds each
time). If the garage door opener/device
activates, programming is complete.
NOTE:
If the garage door opener/device does not
activate,
push the button a third time (for
two seconds) to complete the training.
Loading ...
Loading ...
Loading ...