Loading ...
Loading ...
Loading ...
187
(Continued)
JACKING AND TIRE
CHANGING
NOTE:
If your vehicle is equipped with an air
suspensio
n system, there is a feature which
allows the automatic leveling to be disabled
to assist with changing a tire.
This feature can be activated through the
Uconnect
system.
Refer to “Uconnect Settings” in “Multi-
media” in the Owner’s Manual for further
i
nformati
on.
Jack Location
The jack and jack tools are stored under the
front passenger seat.
F64 – – Spare
F65 – 10 Amp Red Mod ORC
F66 10 Amp Red Run - Accessory Feed
Cavity Cartridge Fuse Micro Fuse Description
CAUTION!
When installing the power distribution
center cover, it is important to ensure
the cover is properly positioned and fully
latched. Failure to do so may allow water
to get into the power distribution center
and possibly result in an electrical
system failure.
When replacing a blown fuse, it is
important to use only a fuse having the
correct amperage rating. The use of a
fuse with a rating other than indicated
may result in a dangerous electrical
system overload. If a properly rated fuse
continues to blow, it indicates a problem
in the circuit that must be corrected.
WARNING!
Do not attempt to change a tire on the
side of the vehicle close to moving
traffic. Pull far enough off the road to
avoid the danger of being hit when oper
-
ating the jack or changing the wheel.
Being under a jacked-up vehicle is
dangerous. The vehicle could slip off the
jack and fall on you. You could be
crushed. Never put any part of your body
under a vehicle that is on a jack. If you
need to get under a raised vehicle, take
it to a service center where it can be
raised on a lift.
Never start or run the engine while the
vehicle is on a jack.
The jack is designed to be used as a tool
for changing tires only. The jack should
not be used to lift the vehicle for service
purposes. The vehicle should be jacked
on a firm level surface only. Avoid ice or
slippery areas.
WARNING! (Continued)
Loading ...
Loading ...
Loading ...