User Manual - Page 164

For RAM 2019 1500 (ALL-NEW).

Loading ...
Loading ...
Loading ...
STARTING AND OPERATING
162
Manual Activation Of The Rear View Camera:
1. Press the "Controls" button located on
the bott
om of the Uconnect display.
2. Press the "Backup Camera" button to
turn t
he Rear View Camera system on.
When the vehicle is shifted out of REVERSE
(
with Cam
era delay turned off), the rear
Camera mode is exited and the previous
screen appears again.
When the vehicle is shifted out of REVERSE
(with Cam
era delay turned on), the rear
Camera image will be displayed for up to 10
seconds after shifting to another gear, unless
the vehicle speed exceeds 8
mph (13 km/h),
the trans
mission is shifted into PARK, the
ignition is switched to the OFF position, or
the touchscreen button “X” to disable
display of the Rear View Camera image is
pressed.
Whenever the Rear View Camera image is
activated
through the "Backup Camera"
button in the "Controls" menu, and the
vehicle speed is greater than, or equal to,
8
mph (13 km/h), a display timer for the
image is
initiated. The image will continue to
be displayed until the display timer exceeds
10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image
will be d
isplayed continuously until deac-
tivated via the touchscreen button "X", the
t
ransmiss
ion is shifted into PARK, or the
ignition is cycled to the OFF position.
The touchscreen button "X" to disable
display of the camera image is made avail-
able ONLY when the vehicle is not in
R
EVERSE.
Wh
en enabled, active guide lines are overlaid
on the im
age to illustrate the width of the
vehicle and its projected backup path based
on the steering wheel position. The active
guide lines will show separate zones that will
help indicate the distance to the rear of the
vehicle.
NOTE:
For further information about how to access
and chang
e the programmable features of
the ParkView Rear Backup Camera, refer to
“Uconnect Settings in Multimedia in
your Owner’s Manual for further information.
The ParkView Camera is located in the center
of the ta
ilgate handle.
WARNING!
Drivers must be careful when backing up
even when using the ParkView Rear Back
Up Camera. Always check carefully behind
your vehicle, and be sure to check for
pedestrians, animals, other vehicles,
obstructions, or blind spots before backing
up. You are responsible for the safety of
your surroundings and must continue to
pay attention while backing up. Failure to
do so can result in serious injury or death.
CAUTION!
To avoid vehicle damage, ParkView
should only be used as a parking aid. The
ParkView camera is unable to view every
obstacle or object in your drive path.
To avoid vehicle damage, the vehicle
must be driven slowly when using
ParkView to be able to stop in time when
an obstacle is seen. It is recommended
that the driver look frequently over his/
her shoulder when using ParkView.
Loading ...
Loading ...
Loading ...