Loading ...
Loading ...
Loading ...
169
The user interface consists of the following:
Manual Brake Control Lever
Slide the manual brake control lever to the
left to a
ctivate power to the trailer's electric
brakes independent of the tow vehicle's
brakes. If the manual brake control lever is
activated while the brake is also applied, the
greater of the two inputs determines the
power sent to the trailer brakes.
The trailer and the vehicle’s stop lamps will
come on w
hen braking normally with the
vehicle brake pedal. Only the trailer stop
lamps will come on when the manual brake
control lever is applied.
Trailer Brake Status Indicator Light
This light indicates the trailer electrical
connectio
n status.
If no electrical connection is detected after
the ignit
ion is turned on, pushing the GAIN
adjustment button or sliding the manual
brake control lever will display the GAIN
setting for 10 seconds and the “Trailer Brake
Status Indicator Light” will not be displayed.
If a fault is detected in the trailer wiring or
the Integ
rated Trailer Brake Module (ITBM),
the “Trailer Brake Status Indicator Light”
will flash.
GAIN Adjustment Buttons (+/-)
Pushing these buttons will adjust the brake
control p
ower output to the trailer brakes in
0.5
increments. The GAIN setting can be
increased
to a maximum of 10 or decreased
to a minimum of 0 (no trailer braking).
GAIN
The GAIN setting is used to set the trailer
brake con
trol for the specific towing condi-
tion and should be changed as towing condi-
tions change. Changes to towing conditions
i
nclude t
railer load, vehicle load, road condi-
tions and weather.
Adjusting GAIN
NOTE:
This should only be performed in a traffic
f
ree envi
ronment at speeds of approximately
20–25
mph (30–40 km/h).
1. Make sure the trailer brakes are in good
working
condition, functioning normally
and properly adjusted. See your trailer
dealer if necessary.
2. Hook up the trailer and make the elec-
trical c
onnections according to the trailer
manufactu
rer's instructions.
3. When a trailer with electric/EOH brakes
is plugg
ed in, the trailer connected
message should appear in the instrument
cluster display (if the connection is not
recognized by the ITBM, braking func
-
tions will not be available), the GAIN
setting w
ill illuminate and the correct
type of trailer must be selected from the
instrument cluster display options.
4. Push the UP or DOWN button on the
steering
wheel until “TRAILER TOW”
appears on the screen.
5. Push the RIGHT arrow on the steering
wheel to
enter “TRAILER TOW”.
6. Push the UP or DOWN buttons until the
Trailer
Brake Type appears on the screen.
7. Push the RIGHT arrow and then push the
UP or DO
WN buttons until the proper
Trailer Brake Type appears on the screen.
8. In a traffic-free environment, tow the
trailer
on a dry, level surface at a speed
of 20–25
mph (30–40
km/h) and
squeeze the manual brake control lever
completely.
Loading ...
Loading ...
Loading ...