Loading ...
Loading ...
Loading ...
©
2019 DJI All Rights Reserved.
77
MATRICE 200
SERIES V2 User Manual
Using the Upward Gimbal and GPS Kit
The M210 V2/M210 RTK V2 supports upward gimbal. The GPS kit is required to obtain better GPS
signal when an upward gimbal is used on the M210 V2 aircraft. Refer to the manuals for the Single
Upward Gimbal Connector and GPS Kit on installation and usage.
The GPS kit has an IP43 ingress protection. However, the aircraft will not retain its IP43
rating if the GPS kit is installed. Users can customize a waterproof rear port cover to
ensure ingress protection.
The M210 V2/M210 RTK V2 supports the simultaneous use of an upward gimbal and a
downward gimbal. The upward gimbal should be connected to Gimbal Connector I only.
Dual Downward Gimbals
The M210 V2/M210 RTK V2 supports dual downward gimbals.
Using the Dual Downward Gimbals
All Zenmuse X5S, X4S, XT, X7, XT2, and Z30 gimbals are supported. You can mount them to the
Gimbal Connector I and Gimbal Connector II as shown below:
Gimbal Connector II Gimbal Connector I
Zenmuse XT Zenmuse X4S/X5S/X7/XT2/Z30
Zenmuse Z30 Zenmuse X4S/X5S/X7/XT/XT2/XT S
Zenmuse XT S Zenmuse X4S/X5S/X7/Z30
Please note that Gimbal Connector II can be mounted with the Zenmuse XT, XT S and Z30 only.
Gimbal Connector I and Gimbal Connector II cannot be mounted with two of the same Zenmuse
gimbals.
Gimbal Connector I's camera view will show on the main interface in the DJI Pilot app, while Gimbal
Connector II's camera view will show on the assistant interface. You can switch between them.
When using the Zenmuse Z30 and X7 cameras together, they might obstruct each other's
motion at certain angles.
If using only one camera be sure to install the gimbal and camera on Gimbal Connector I
and not on Gimbal Connector II.
Gimbal
Connector II
Gimbal
Connector I
Loading ...
Loading ...